Product Tips & Tutorials: RC Accessories
How Do I Bind My 2.4ghz FLYSKY Radio System?
Posted by on 17 September 2012 08:58 AM
1. Put batteries into the transmitter

2. Place bind plug into the BATT slot on the receiver

3. Connect a receiver battery (6.0v) to any channel on the receiver OR place an esc with battery into channel 3 on receiver

4. Press and HOLD bind button on transmitter and turn on transmitter 

5. Continue holding bind button without releasing and observe the RECEIVER light. The receiver light should go out indicating binding successful. May take up to 10+ seconds

6. Remove Bind Plug and place battery into BATT slot OR ESC into channel 3 with battery

7. Install servos and test

If fail, repeat from step one.

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.